COLOURTREND Elastomeric Flexible Membrane Water-Proofing 10L

FEATURES:

Excellent water resistance, superior adhesion. It is highly resistant to atmospheric exposure, infra-red and ultra-violet radiation, and will actively inhibit corrosion. With exceptional toughness and resilience designed to coat rusty surfaces without expensive preparation.

APPLICATION:

Colourtrend Elastomeric Flexible Membrane has been developed for the long term protection and weatherproofing of concrete buildings, hotels, shopping complexes, schools, hospitals, bungalows, commercial buildings, galvanised iron roofs, steel, iron, bridges, waterproofing concrete, block buildings, storage tanks, freezing works, oil refineries, breweries, etc.

WATERPROOFING ALL TYPES OF ROOFS:

Super Six fibre cement roofs, plywood roofs, galvanised iron, concrete tiles, concrete, asbestos, Decromastic Chip roofs, and any surface that requires a roof mastic. It is also used in hospitals, schools, and factories, freezing works, and all types of food industries – giving excellent protection against mould fungus. It is ideal for hygiene areas with M.A.F. Approval.

On plywood roof systems the use of embedded mesh provides a total roofing system.

COLOURTREND ELASTOMERIC FLEXIBLE MEMBRANE – FLOORING GRADE:

Flooring grade is produced as a non-slip durable floor coating for steps, tennis courts, flooring, patios, decks, boats, ships, swimming pool surrounds, workshops, etc.

COLOURTREND FIRETECH:

Colourtrend Firetech will coat steel, timber and drastically reduce ignitability and the spread of flame.

COLOURTREND ELASTOMERIC FLEXIBLE MEMBRANE:

APPLICATION: Brush, roller or airless spray

CLEAN UP: Water or Brush Clean Solvent when dry

THINNING: Do not thin

DRYING TIMES:

Colourtrend Elastomeric Flexible Membrane will dry and can be recoated after 2 hours at 20oC – in cold or humid conditions.

Allow 8 hours before application of second coat.

COVERAGE:

2 – 4 m2 per litre per coat minimum two coats for concrete walls / roofs. (1 litre of Colourtrend Elastomeric Flexible Membrane per 1 m2 achieved with 2 coats provides a dry film build of 0.500 – 0.600 microns.)

NUMBER OF COATS:

Always apply 2 – 3 coats for concrete walls / minimum DFT 300 – 500.

Plywood roof systems – 4 – 5 coats recommended with fibre mesh embedded minimum DFT 1200 microns –

1500 microns. All decks minimum 1500 microns DFT.

PRIMING / SEALING:

Use correct Sealers on concrete and fibrolite. Multiseal on all timber including plywood, primers to be used on galvanised iron, steel and bridge structures, etc.

Always refer to preparation specification sheets before any application.

PREPARATION:

New and old concrete must be waterblasted and then Acid Etched. Apply appropriate Sealer. Rust to be wire-brushed, then converted with Metaltech Rust Converter, then apply 1 coat of Metaltech Primer.

Galvanised iron to be cleaned with Chemocide Etch to remove oxidation, then primed with Tetracure P10.

PACKAGING: 4 Litre, 10 Litre plastic pails