Epotread H200 is a two-pack heavy duty waterbased epoxy coating manufactured with the latest epoxy resin technology, specially formulated for easy mixing and roller application.
Epotread H200 is a semi gloss, hardwearing, solvent free epoxy coating with excellent chemical resistance, making it an ideal surface for floor areas subject to vehicle traffic.
Epotread H200 is formulated using the latest waterbased epoxy resin technology, which creates a coating that is incredibly tough and long lasting with very good oil and chemical resistance.
This Two pack paint has superb adhesion qualities, has excellent tolerance to high levels of moisture in concrete and hydrostatic pressure once cured.
Epotread H200 is simple to mix and easy to apply by brush or roller.
PRODUCT FEATURES
- Durable and hardwearing
- Incredible adhesion to stable concrete
- Non-toxic and solvent free
- Available in 12 standard colours, plus tinting on request
- Apply by brush, roller or airless sprayer
- Excellent fuel, oil and grease resistance
- 4:3 mix ratio (Part A and Part B)
USE AREAS
- Floors of automotive workshops, garages, aircraft hangars
- Factory, warehouse and showroom floors
- Concrete protection in wineries and beverage industries
- Extremely durable and easy clean interior wall finish
- Timber floors of garages and work areas
APPLICATION INSTRUCTIONS
Surface Preparation
Ensure the substrate is in clean and sound condition. The surface must be free of dirt, oil, grease and loose material. Remove oil using Omniwash detergent or similar. Pre-painted surfaces must be clean and dry. Any loose or bubbling paint must be removed by diamond grinding. New or very smooth concrete should be either diamond ground or etched with Hydrochloric Acid then thoroughly waterblasted. Diamond grinding is recommended on older floors. If the concrete substrate has a rising dampness issue, apply a primer coat of Epotread Moistureseal. Cracks can be cut out using a diamond cutting blade on an angle grinder, then filled with Cretex SL epoxy resin. Refer to Cretex SL Data sheet. Timber floors should be prepared by sufficient sanding and lightly sanded between each coat.
Mixing Directions
Wear impervious nitrile disposable gloves. Stir the Part A thoroughly to ensure that no pigment has settled. Combine Part A with Part B at the correct volume ratio (4:3 by volume) and mix thoroughly for at least 1 minute ensuring a consistent mix. A spiral mixer on a variable-speed power drill is recommended. Scrape around the sides of the mixing pail with a spatula and ensure that no unmixed ingredient is on the sides or bottom of the pail. Pour the mixed material into a clean pail. Thin 15% with water for the first coat only to aid the penetration on unpainted concrete.
Important: If thinning, combine Part A and B together, mix thoroughly, then add the measured amount of water and mix thoroughly again.
Pot life
Once mixed the maximum working time is 1½ hours @ 20°C.
Application
Apply the mixed Epotread H200 to the prepared surface evenly by roller using a 10mm roller sleeve. If using an airless sprayer, the first coat application should be immediately followed up with a roller while wet to help penetration into small voids and ensure no air is trapped in the substrate. Avoid thinning the Epotread H200 for the top coat. Air fans should be used to assist the drying of the top coat if drying is slow.
CLEANING OF TOOLS
Equipment and tools should be cleaned immediately after use with warm water and detergent, as once cured it becomes very hard to remove. A new roller sleeve is recommended for each coat. Spraying equipment must be flushed and cleaned very thoroughly without delay, with plenty of clean water and approved sprayer cleaning chemical